Member Credit: Chernmax
OK, the Injen CAI mounting SUCKS, driving vibration first took out the rubber boot mounting screw, I reinforced the mounting and the freaken weld broke… DAMM… So some of you might have this (see pic below)
My Fix, about $20 clams:
Parts Used:
1- ROL Exhaust heavy duty tail pipe hanger.
2- 2 RE Works High Grade Aluminum Quick Release Racing Clamps
The task: Using a vice, I bent the Exhaust bracket in a 90 degree angle and attached it to the lower engine mounting bolt just below the Injen, using 1 clamp, I added a new forward midbody support clamp by hooking it around the Exhaust Hanging bracket U-hook, (The Rubber vibration spacer allowed it to twist nicely into place and is 50 times stronger than the stock shock mount).
Another benefit; the bracket is now mounted under the CAI and eliminated all stress on the mounting hardware. I also replaced the rear bracket (not required, however stronger), tightened down all. Job time, 17 minutes…
Comments are closed.