Last Updated: 02/12/2017 @ 02:25 pm
Member Credit: Elite Package
Hey guys i just recently painted the interior of my lights black to match my car. I just figured i’d write this post to help anyone out by giving “visual” instructions rather then “Text” instructions. So if you decide to tackle this project yourself like i did, hopefully you will gain enough confidence by the end of the thread to complete it successfully. Here we go!
Start of by removing two phillips head screws underneath the bumper.
Next remove all plastic clips holding plastic cover underneath the engine.
Now, move plastic cover aside near the wheel to acess two vertical phillips head screws, remove those too.
Next, remove all plastic clips holding down the grille.
Also, remove all plastic clips holding down plastic cover over your windshield washer reservoir.
Finally, remove plastic clip holding down bumper cover to car body.
You should now be able to pull bumper off of the body.
– – – – –
Now you are ready to remove headlight.
Start off by removing 4-5 hex head screws.
Now that the headlight is loosened from the body, disconnect your fog light wires.
Untwist Cover
Disconnect small clip
Disconnect what i believe to be a factory ballast underneath the headlight.
You will now need to remove 4 phillips head screws on the exterior portion of the headlight unit. (2 with a washer that hold wires in place 2 small ones without a washer that hold a bracket in place)
Once these are off you should be able to remove the headlight.
Comments are closed.